I hear you describe how to make a power vent with aluminum ducting going to an inch above one's basement floor, then put on a timer for 12 hours from 9 p.m. . does this create a negative pressure within the home that would draw back in carbon monoxide gases from the vent off the hot water tank being vented out through the chimney ?
Answer:
I would certainly not vent it via the same stack as anything but a clothes dryer because I don't know enough about negative pressure but I do know that it works.Cold air holds more moisture than warm air and is, therefore, heavier. As air cools, it falls and keeps falling until it reaches the lowest level in the house. It cannot fall beyond the basement floor and that is where it has to be collected and pumped outside before that moisture gets a chance to condense in order to get rid of the moldy, musty odour and/or avoid it in the first place. A booster fan (250 CFM +) is available as a ‘pop in’ unit to fit 4”, 5” or 6” round heating duct. This can be installed in a totally separate duct line that is at least six feet from the nearest heat source. A timer on it will ensure that it operates only during the night (9pm to 9am) so cold, moist air it pumps out is not replaced by air that brings in even more humidity from outside. All joints and seams in the duct are taped and sealed for maximum efficiency and rather than a heating-type grill it should be a return air-type grill. To avoid having to core another hole in the foundation wall, this system can be vented, via a “TY” through the clothes dryer vent. Because none of the doors in the house go all the way to the floor, cold, moist air should find its way to that grill.
